|
AP
Outdoors
6305 Glenn Carlson Drive
St. Cloud, MN 56301
1-800-526-8810 Local: 320-252-8810
info@apoutdoors.com
| |
|
|
|
|
|
|
|
|
Locate metallic pellets & fragments in meat/game prior to
eating.
The Savertooth™ assists in the detection of unseen steel, lead fragments and lead shot in
hunted wild game. The LED indicator illuminates and beeper sounds when
the unit detects metal objects. Save yourself from damaging your teeth
on shot. Use on duck, goose, pheasant, deer, buck, grouse and all other
game taken with a shotgun.
|
Locate metallic pellets in meat/game prior
to eating.
The Savertooth™ detects unseen steel and lead shot in hunted game so
you don't damage or break your teeth on shot! |
|
About The
Savertooth™
Savertooth™ assists in the detection of unseen steel, lead shot and
lead fragments in hunted wild game saving your teeth from potential
damage. The LED indicator illuminates and beeper sounds when the
unit detects metal objects.
To Use The
Savertooth™
Turn on the detector by rotating the thumbwheel. The red LED
indicator will glow, and the beeper will sound briefly. Rotate the
thumbwheel until the red LED stops glowing. Hold the detector with
your hand gripping behind the thumbwheel -- moving it sideways
across the sliced sections of meat until it senses metal. Remove
pellet(s) from the meat. Rescan that same area thoroughly to make
sure all metal has been removed from the area where metal was
detected. It may be necessary to adjust the sensitivity of the
detector by rotating the thumbwheel. The detector is most sensitive
when adjusted by rotating the thumbwheel slightly past the position
where the red LED has just stopped glowing. Clean the unit with a
moist soft cloth and mild detergent, and wipe dry. Do not submerge
in water or dishwasher.
Troubleshooting
the Savertooth
First, if the red LED does not glow and the beeper does not sound
when operating the unit, or if the sensitivity is reduced, replace
the battery with a new alkaline 9-volt DC battery. Second, in the
unlikely event that the LED does not glow or stays on continuously,
the unit can be adjusted from the inside. To make this adjustment,
turn the calibration screw in either direction until the LED
indicator glows or stops glowing, depending on its condition. Keep
in mind this is not a comprehensive diagnostic instrument.
Pinpointing the exact location of metal depends on the condition of
the internal battery and adjustment of the sensitivity thumbwheel.
Caution: Use extreme care with the Savertooth™. This product is
designed as an aid in locating hidden metallic pellets that may be
lodged in wild game taken by firearms. A very thorough scan of all
possible locations from a maximum of 1/4 inch depth is required to
assure that the meat is absent of metal pellets. Indicating Systems
Inc. assumes basic knowledge of electricity on the part of the
purchaser and is not responsible for injury or damages due to misuse
of the product. |
|
| 
|
SaverTooth™
MSRP
$31.99
|
|
|
|
